Add a sampling point in Ecobot Collector

  • Updated

Sampling points are where you record your data in the field. This article shows you how to add a point in Ecobot Collector, from the survey page or from the map, and how to average its location for better accuracy.

The survey has to be checked out to your device first. See How syncing works: check-in, checkout, and sync.

Add a point from the survey page

  1. Open the survey, then tap Add Point at the bottom right.

    A survey's point list in Ecobot Collector, with the Add Point button highlighted

  2. The Add Point screen opens with your current location: the Location Provider, Latitude, Longitude and Altitude.
  3. Enter a Sampling Point Name, such as A1. It's the only required field.
  4. Next to Average, choose how long to average your location: Instant (a single reading), 5s (the default), 10s or 15s. See the next section.

    The Add Point screen in Ecobot Collector, with the Sampling Point Name, the location, Average set to 5s and the Add Point button

  5. Tap Add Point.

The new point opens, so you can start entering its data.

Average the point's location

Instead of using a single location reading, Collector can take several readings (fixes) over a few seconds and save their average as the point's location. This evens out the small jumps in a GPS signal. It works with your phone's built-in GPS and with an external GNSS receiver.

When you tap Add Point with 5s, 10s or 15s chosen, hold still until the countdown ends. Collector shows how many seconds are left and how many fixes it has taken so far.

Ecobot Collector averaging a point's location, showing Hold still, the seconds left, the number of fixes and Cancel

To stop, tap Cancel. The point isn't saved.

For more on location accuracy, see Location data in Ecobot.

Add a point from the map

  1. Open the survey's map.
  2. Tap Add Feature, then Sampling Point at the top of the list.

    The Add Feature menu on the Ecobot Collector map, with Sampling Point highlighted

  3. Fill in the Add Point screen and tap Add Point, the same way as from the survey page.

For everything else on the map, see Mapping in Collector.

Other ways to add a point